The function of this section is to go over how you can add new runs from the route planning system. This includes information about adding new runs, confirming the information has been saved, and what to do if certain information doesn't show up.
1. Go to the Operations tab and select Runs.
2. As shown below, it will bring you to the Manage Runs screen.
3. Select Route interface, then select Add new runs.
4. A pop up window will appear. This allows you to make a blanket change for the runs that you will be adding. It is important to note that it is simple to change these setting on the individual routes when connected. Click connect after making your selections.
5. The screen, "Add runs" will then appear. Here you can select the runs you would like to add from the route planning system. If adjustments need to be made. You can click on the specific run name and the editing process can begin. After you are done, click on the "back" arrow to the far right and the changes will be made. The screen shot below reflects what was explained. After you have completed any changes. Click Add.
You have now completed the process of adding new runs from the route planning system.
NOTE: If you are having a gap in information, it could be because school names within the route planning system do not match up with the EXACT spelling (case sensitive) that is in the Bytecurve360 system . You must change the names within the Bytecurve360 system to match with those within your route planning system. It could also be a instance where the school codes do not match. A example of the error is posted below for reference.
